5kWh LiFePO4 Powerwall

Features：

● No load loss is small, less than half of the same power high-frequency machine

● Pure sine wave output, can adapt to different loads

● Output short circuit protection function

● Multiple parameters can be adjusted according to user needs

● Optional solar controller with PWM/MPPT

● Optional with BMS communication function

● RS485 communication function is optional

● Smart battery charger design for optimized battery performance

● Built in Transformer, overload and Ultra-high voltage protection

● Self-design PCB board and cooling system

● Auto Restart when Ac in recovering

● High Efficiency Design &"Power Saving Mode"to Conserve Energy

 

Item Name	5kWh Lifepo4 Powerwall
Rated power	5120Wh
Rated capacity	100Ah
Rated voltage	51.2V
Max charging voltage	58.4V (57V best)
Discharge cutoff voltage	43.2V
Internal Resistance	≤25mΩ
Continuous charging current	20
Maximum continuous charging current	50
Standard discharge current	20
Maximum continuous discharge current	100
Charging temperature range	-10~55℃
Discharge temperature range	-20℃~60℃
Periodicity index	≥4000 times,25℃
Periodicity index	IP21
Size	562mm*435mm*138.55mm
Weight	About 48kg

 

How to install?

1) Before installation, make sure the wall thickness is >60mm, remove the wall plate and mark the fixing holes for the plate on the wall;

2) Drill holes at the marked hole positions with an M8 drill bit to a depth of 50mm; drill the holes in the following positions:

3) Take out the battery pack fixing bracket and fix the fixing bracket on the wall according to the screw hole position, then use a hammer to knock the expansion bolts in the accessory pack into the hole position and tighten the bolts;

4) Then two people will snap the back of the battery pack into the fixing bracket, and the installation is completed.