The electrochemical reaction formula of the valve-regulated lead-acid battery is shown below. Charging is to connect an external DC power supply to the battery to charge it, so that electrical energy is converted into chemical energy and stored. Discharging is the release of electrical energy from the battery to drive external devices.
When the VRLA battery is about to reach its peak charge, the charging current is only used to decompose the water in the electrolyte. At this time, the positive electrode of the battery produces oxygen and the negative electrode produces hydrogen. The gas will overflow from the battery, causing the electrolyte to decrease and requiring water to be added from time to time.
On the other hand, at the end of charging or under overcharge conditions, the charging energy is used to decompose water. The oxygen produced by the positive electrode reacts with the spongy lead at the negative electrode, leaving part of the negative electrode in an underfilled state, inhibiting the generation of hydrogen at the negative electrode.
Conditions of use
(1) Avoid direct contact between the battery and metal containers. Acid-proof and heat-resistant materials should be used. Otherwise, it will cause smoke or combustion.
(2) Use the specified charger and charge under specified conditions. Otherwise, it may cause the battery to overheat, release gas, leak, burn or rupture.
(3) Do not install the battery in a sealed device. Otherwise, the device may rupture.
(4) When using batteries in medical equipment, please install a backup power supply in addition to the main power supply, otherwise failure of the main power supply may cause injury.
(5) Keep the battery away from spark-generating equipment, otherwise sparks may cause the battery to smoke or rupture.
(6) Do not place the battery near a heat source (such as a transformer), otherwise it may cause the battery to overheat, leak, burn or rupture.
(7) When there are more than one battery in the application, please ensure that the connection between the batteries is correct and that the connection with the charger or load is correct, otherwise it may cause the battery to rupture, burn or be damaged, and in some cases may even injure people.
(8) Be especially careful not to let the battery fall on your feet.
(9) The specified range of use of the battery is as follows. Exceeding this range may cause battery damage.
Normal operating range of the battery is: 77.F (25℃)
After battery discharge (installed in the device): 5.F to 122.F (-15℃ to 50℃)
After charging: 32.F to 104.F (0℃ to 40℃)
In storage: 5.F to 104.F (-15℃ to 40℃)
(10) Do not place the battery installed on the motorcycle in high temperature, direct sunlight, stove or fire, otherwise it may cause battery leakage, fire or rupture.
(11) Do not use the battery in dusty places, which may cause the battery to short circuit. When using the battery in a dusty environment, check the battery regularly.
Electrochemical reactions in electrodes
Oct 25, 2024
Leave a message
